| |
Quality
built for heavy duty
cycles and reduced maintenance.
Galvanized winches for optimal corrosion protection are available!
|
 |
- Thermostatically
protected motor
- Special
high-inertia brake discs resist wear and heat build up caused
by constant start and stop operation
- High-capacity
roller bearing on high-speed shaft for reduced maintenance
- Options
include groove drum, radio controls, saltwater corrosion protection
and angle foot mounts
- Standard
control panel. Optional remote push buttons and optional radio
control available
- Variable
speed motors optional
- Patterson
barge haul winches are usually built to customer specifications.
Dimensions and specifications below are typical for the most
common configuration
|
*Standard
Barge Haul
Winch WWP30-7.5-26R
 |
|
WWP30-7.5-26R |
|
Brake/Dog
Holding Capacity (lbs.) |
60,000 |
|
Rated
Pull - 1st Wrap (lbs.) |
8,500 |
|
Stall
Pull - 1st Wrap (lbs.) |
21,000 |
|
Line
Speed - 1st Wrap |
21
FPM |
| Motor: |
|
|
Type |
NEMA
Design D |
|
Horsepower |
7.5 |
|
Electrical
Requirements |
230/460V
60Hz, 3 Phase |
| Dimensions: |
|
|
Base
Width |
44" |
|
Base
Length |
37" |
|
Overall
Width |
45" |
|
Overall
Length |
37" |
|
Overall
Height |
37
1/2" |
|
Net
Weight (lbs.) |
2,050 |
|
Shipping
Weight (lbs.) |
2,100 |
|
Drum
Capacities: |
|
|
Rope
Diameter |
5/8"
3/4" 7/8" |
|
Drum
Capacity |
540'
375' 275' |
|
*All
performance data and specifications set forth in the above table
are guidelines. The referenced data and specifications were produced
under controlled testing conditions and should be used as estimates
only. Due to variability in individual operators, in weather,
in towing conditions, and in various other factors, actual results
may vary. In addition, for the purpose of installation, please
verify all dimensions as the dimensions, specifications, data
and other information contained on this site are subject to change
at any time without notice. |
|
